Division 01

Electronics that are designed to be built.

We take hardware from first idea to a board that works, can be tested and can be produced — with the firmware and software in mind from day one.

Electronics & Hardware

What we do

Electronics & Hardware

01
Electronic engineering
Circuit architecture, component selection, power design and signal integrity for analog, digital and mixed-signal systems.
02
PCB design and manufacturing
Single- to multi-layer board layout, design-for-manufacturing review and preparation of prototype and production runs.
03
Embedded systems
Microcontroller and processor-based designs with firmware, communication interfaces and low-power operation.
04
Electronic modules and components
Reusable modules — control boards, sensor and communication units — that shorten the path to new products.
05
Hardware product development
Complete devices: electronics, enclosure considerations, testing and documentation, prepared for production.

How we work

01
Requirements first
Electrical, environmental and cost targets are fixed before the first schematic.
02
Design for test
Test points, programming access and diagnostics are designed in, not added later.
03
Prototype and measure
Every revision is built and measured; decisions follow the data.

Typical applications

Other divisions

Let’s build the future

Tell us about your idea, product or challenge. We will get back to you to talk through what is possible.